Forrest DH10807100 Duraline 10-Inch 80 Tooth HI-A/T Thin Kerf Melamine and Plywood Cutting Saw Blade with 5/8-Inch Arbor

From the Manufacturer The Forrest DH10807100 Duraline 10-Inch 80 Tooth HI-A/T Thin Kerf Melamine and Plywood Cutting Saw Blade with 5/8-Inch Arbor features blades that offer a superior cut, leaving a rip-cut saw edge that is as smooth as if it had been sanded, and a cross-cut edge that is almost mark-free. The blades run very quietly, and backside tearout in plywood is negligible. Each blade is virtually hand-made. The plate is hand-tensioned (up to 15 minutes per blade), superior C-4 carbide teeth are hand-brazed to the plate, and the blade is straightened and restraightened multiple times throughout the process. Think of a Forrest blade as a tool in your shop, not an accessory. Forrest stands behind it’s blades by offering a sharpening service that bring blades back to the exact tolerances offered in a new blade. And this same exacting service is available for other manufacturer’s blades as well, so they should come back better than new. Forrest Woodworker 2 Saw Blade For Table Saws. With this one all purpose blade you can RIP & CROSSCUT 1″ to 2″ hardwood and softwood resulting in a smooth as sanded surface. Ply-veneers of oak and birch will crosscut with NO BOTTOM SPLINTER at moderate feed rates. Customized Forrest Woodworker 2 For Table Saws. For the advanced table saw operator. Ideal for joinery and special uses. Specially engineered clearances on the carbide teeth can totally eliminate side scoring. The result…no planing/jointing or sanding. In many cases a glue-line cut can be obtained, depending on the accuracy of the saw machine.

Features

• 20deg Face Hook for easy feed
• DOUBLE HARD and 40% STRONGER C-4 CARBIDE will give up to 300% longer life between sharpenings.
• Ends second-step finishing (jointing and sanding not required).
• Buy and sharpen ONE blade instead of 3, (24T Rip, 50T Combination, 80T Crosscut).
• Ends cutting 1/16″ oversize to allow for RESURFACING